Please use the BACK button on your browser to return to the previous page.

Entering Confined Spaces


This checklist is not all-inclusive. You should add to it or delete items that do not apply to your business; however, carefully consider each item and make your decision. You should refer to Minnesota statutes and rules, and federal OSHA standards adopted by reference in Minnesota for specific guidance that may apply to your work situation (see www.dli.mn.gov/). (Note: This checklist is typical for general industry but not for construction or maritime industries.)
  • Are confined spaces thoroughly emptied of any corrosive or hazardous substances, such as acids or caustics, before entry?
  • Are all lines to a confined space that contain inert, toxic, flammable, or corrosive materials valved off and blanked or disconnected and separated before entry?
  • Are all impellers, agitators, or other moving parts and equipment inside confined spaces locked out if they present a hazard?
  • Is either natural or mechanical ventilation provided prior to confined space entry?
  • Are appropriate atmospheric tests performed to check for oxygen deficiency, toxic substances and explosive concentrations in the confined space before entry?
  • Is adequate illumination provided for the work to be performed in the confined space?
  • Is the atmosphere inside the confined space frequently tested or continuously monitored during work?
  • Is there a trained and equipped standby employee positioned outside the confined space, whose sole responsibility is to watch the work in progress, sound an alarm if necessary and render assistance?
  • Is the standby employee appropriately trained and equipped to handle an emergency?
  • Are employees prohibited from entering the confined space without lifelines and respiratory equipment if there is any question as to the cause of an emergency?
  • Is approved respiratory equipment required if the atmosphere inside the confined space cannot be made acceptable?
  • Is all portable electrical equipment used inside confined spaces either grounded and insulated or equipped with ground fault protection?
  • Are compressed gas bottles forbidden inside the confined space?
  • Before gas welding or burning is started in a confined space, are hoses checked for leaks, torches lighted only outside the confined area and the confined area tested for an explosive atmosphere each time before a lighted torch is taken into the confined space?
  • If employees will be using oxygen-consuming equipment such as salamanders, torches, furnaces, etc., in a confined space, is sufficient air provided to assure combustion without reducing the oxygen concentration of the atmosphere below 19.5 percent by volume?
  • Whenever combustion-type equipment is used in a confined space, are provisions made to ensure the exhaust gases are vented outside of the enclosure?
  • Is each confined space checked for decaying vegetation or animal matter which may produce methane?
  • Is the confined space checked for possible industrial waste which could contain toxic properties?
  • If the confined space is below ground and near areas where motor vehicles will be operating, is it possible for vehicle exhaust or carbon monoxide to enter the space?
Source: Federal OSHA